Diagnose and configure Ford Focus 2 and C-Max I modules using ELM327 or ELS27. These interfaces allow access to CAN-bus connected modules:

Engine Control Module (ECM): Access module information, read and clear diagnostic trouble codes (DTCs), reboot the module, and reset the long-term fuel trim (KAM)* for the following ECUs: ESU-411/418 (1.8 125/2.0 145), SIM28/29 (1.4 80/1.6 100/115), and ESU-121/131 (1.8 120/2.0 145).

Instrument Panel Cluster (IPC): Access module information, read and clear DTCs, configure the module, reboot the module, change the odometer reading, and correct the odometer reading*.

Brake Control Module (BCM): Access module information, read and clear DTCs, configure the module, reboot the module, reset the Dynamic Stability System (DDS) calibration, and perform brake bleeding*.

Body Control Module (BCM): Access module information, read and clear DTCs, configure the module*, and reboot the module.

Airbag Control Module (ACM): Access module information, read and clear DTCs, configure the module, reboot the module, and clear crash data*.

Transmission Control Module (TCM): Access module information, read and clear DTCs, and reset KAM*.

Climate Control Module (CCM): Access module information, read and clear DTCs.

Audio Control Module: Access module information, read and clear DTCs, and retrieve the radio code (for M series)*.

* Some features are only available in the full version.

To unlock full application functionality and access additional modules, a minor modification to the ELM327 adapter is required. Instructions can be found here: [ttpp]

ELS27 can be purchased at: [yyxx]. For ELS27USB, set the baud rate to 38400; for ELS27BT, set it to 2,000,000 using the ELS27 Baudrate utility.